Gcode control of the Z axis (low priority).Manually control the laser to focus, mirror alignment etc using "Test" button (software control would be ok.).provide audible / visual alarm for over temperature. ![]() shut down the laser if the water temperature goes above a certain limit.keep the water flow interlock on the cooling system.led on the front panel to be lit whenever the laser is firing.add door interlocks to stop the laser firing when a door is open.Limit the maximum current supplied to the laser to prevent burnout.untethered operation - ok to connect to upload the job but not leave a pc there for the duration.(this is currently set manually at the start of each operation) full g-code control of the laser power.limit switch board with LM358p op-amp. ![]() Lihuiyu studio lab 6C6879-LEDPAD-A laser power controller.moving Z platform with DC motor (manual up and down control). ![]()
0 Comments
Leave a Reply. |